Installing And Removing Dimms - Supermicro C2SEA User Manual

Possible System Memory Allocation & Availability
System Device
Firmware Hub fl ash memory (System
BIOS)
Local APIC
Area Reserved for the chipset
I/O APIC (4 Kbytes)
PCI Enumeration Area 1
PCI Express (256 MB)
PCI Enumeration Area 2 (if needed)
-Aligned on 256-MB boundary-
VGA Memory
TSEG
Memory available to OS and other ap-
plications

Installing and Removing DIMMs

Release
C2SEA/C2SEE
To Install: Insert module vertically and press down until it
snaps into place. Pay attention to the alignment notch at the
bottom.
To Remove:
Use your thumbs
to gently push
the release tabs
near both ends of
the module. This
should release it
from the slot.
Size Physical Memory
Remaining (-Available)
(4 GB Total System Memory)
1 MB 3.99
4 KB 3.99
2 MB 3.99
4 KB 3.99
256 MB 3.76
256 MB 3.51
512 MB 3.01
16 MB 2.85
1 MB 2.84
2.84
DDR3
Notch
Note: Notch
Tab
should align
with the
receptive point
on the slot
Top View of DDR3 Slot
2-7
Chapter 2: Installation
Notch
Release
Tab