Installing And Removing The Memory Modules; Installing & Removing Dimms; Removing Memory Modules - Supermicro X10DRT-B+ User Manual

2-4

Installing and Removing the Memory Modules

Note: Check Supermicro's website for recommended memory modules.
Exercise extreme care when installing or removing DIMM
Installing & Removing DIMMs
1. Insert the desired number of DIMMs into the memory slots, starting with
P1-DIMMA1. (For best performance, please use the memory modules of the
same type and speed on the same motherboard.)
2. Push the release tabs outwards on both ends of the DIMM slot to unlock it.
VGA
UID_LED1
LE6
USB0/1
IPMI_LAN
(3.0)
JBAT1
BMC_HB_LED1
Battery
BMC
BIOS
4
3 FLASH
2
1
C612
JBT1
X10DRT-B+
Rev. 1.01
JSD1
BAR CODE
3. Align the key of the DIMM module with the receptive point on the memory
slot.
4. Align the notches on both ends of the module against the receptive points on
the ends of the slot.
5. Use two thumbs together to press the notches on both ends of the module
straight down into the slot until the module snaps into place.
6. Press the release tabs to the locking positions to secure the DIMM module
into the slot.
Press both notches straight
down into the memory slot at
the same time.

Removing Memory Modules

Press the release tabs on both ends of the memory module to unlock it. Once it is
loosened, remove the DIMM module from the memory slot.
modules to prevent any possible damage.
FAN3
FAN4
SIOM: CPU1 PCI-E 3.0 X16
IPMI CODE
BIOS
LICENSE
CPU1
OPEN 1st
1
CPU2
1
CAUTION
Release Tabs
2-11
Chapter 2: Installation
Notches