Advanced Chipset Settings - Supermicro C2SEA User Manual

C2SEA/C2SEE User's Manual

Advanced Chipset Settings

The items included in the Advanced Settings submenu are listed below:
NorthBridge Confi guration
This feature allows the user to confi gure the settings for the Intel 945GME
NorthBridge chipset.
Memory Remap Feature
PCI memory resources will overlap with the total physical memory if 4GB of
memory or above is installed on the motherboard. When this occurs, Enable this
function to reallocate the overlapped physical memory to a location above the
total physical memory to resolve the memory overlapping situation.The options
are Enabled and Disabled.
PCI MMIO Allocation
Use this feature to assign the address for PCI Memory-mapped IO (MMIO)
allocation. The Default setting is 4 GB to 3072 MB.
DRAM Frequency
This feature allows the user to select the DRAM Frequency setting. The options
are Auto (Auto-detect), 533 MHz, 667 MHz, 800 MHz, and 1067 MHz.
Confi guring DRAM Timing by SPD
Select Enable to allow the BIOS to read the SPD (Serial Presence Detect) chip
which is built in the memory module in order to get the exact memory specifi ca-
tions. The options are Enabled and Disabled.
Memory Hole
Use the feature to allocate memory resource reserved for use of PCI devices. If
set to 15 MB~16MB, the reserved memory will be placed in the location around
15 MB~16 MB. The options are Disabled and 15 MB~ 16 MB.
Initiate Graphic Adapter
Use the feature to select the graphics controller to be used as the primary boot
device. The options are IGD, PCI/IGD, PCI/PEG, PEG/IGD, and PEG/PCI.
IGD Graphics Mode Select
Use the feature to set the amount of system memory to be used by the Internal
Graphics Devices. The options are Disabled, Enabled 32 MB, Enabled 64 MB,
and Enabled 128 MB.
4-8