Usb Wake-Up - Supermicro C2SEA User Manual

USB Wake-Up

Use JPUSB jumpers to enable the function of
"System Wake-Up via USB devices", which al-
lows you to "wake-up" the system by pressing a
key on the USB keyboard or by clicking the USB
mouse of your system. The JPUSB jumpers are
used together with the USB Wake-Up function in
the BIOS. Enable both the jumpers and the BIOS
setting to allow the system to "wake-up via USB
Devices". See the table on the right for jumper
settings and jumper connections.
Note: JPUSB1 is for Back Panel USB
ports:0~1, 2~5, and JPUSB2 is for Front
Panel USB ports:6, 8~9 and 10~11.) The
default jumper setting for the Front Panel
USB ports is Disabled. However, when the
"USB Wake-Up" function is enabled in the BIOS,
and the desired USB ports are enabled via the
JPUSB jumper, please be sure to remove all
USB devices from the USB ports whose USB
jumpers are set to "Disabled" before the system
goes into the standby mode.
CPU
Fan5
A
G45 (C2SEA)
G43 (C2SEE)
Slot7 PCI-E x1
JPL1
Slot6 PCI-E Gen2 x16
Lan
CTRL
Slot5 PCI 33MHZ
Slot4 PCI-E x4 on x16
FP Audio
Slot3 PCI 33MHz
CD1
Slot2 PCI 33MHz
S I/O
JPAC JWOL1
Slot1 PCI 33MHz
Floopy
Printer JWOR
COM1
Fan1
Intel
C2SEA/C2SEE
SPI BIOS
JBT1
Intel
CMOS CLEAR
JLED1
ICH10
Battery
JWD1
JOH1
I-SATA0
I-SATA4
I-SATA1
I-SATA5
JD1
I-SATA2
USB 10/11
JPD1
SPKR1
I-SATA3
JPI1
IDE
JPUSB2
USB 8/9
CTRL
USB6
USB7
IDE Fan4
1394_1 1394_2
2-27
Chapter 2: Installation
JPUSB1 (Back Panel USB
Wake-up)
Pin# Defi nition
1-2 Enabled (Default)
2-3 Disabled
JPUSB2 (Front Panel USB
Wake-up)
Pin# Defi nition
1-2 Enabled
2-3 Disabled (default)
A. JPUSB1
B. JPUSB2
B