Chapter 6: Device Management
Resetting the KX II-101-V2 Using the Reset Button
134
8. Click OK to configure the analog KVM switch.
To restore analog KVM switch defaults:
Click Reset to Defaults.
On the top of the device, there is a Reset button. It is recessed to
prevent accidental resets (you will need a pointed object to press this
button).
The actions that are performed when the Reset button is pressed are
defined in the graphical user interface. See Encryption & Share.
To reset the device:
1. Power off the KX II-101-V2.
2. Use a pointed object to press and hold the Reset button.
3. While continuing to hold the Reset button, power the KX II-101-V2
device back on.
4. Continue holding the Reset button for 10 seconds.
5. Release the Reset button and the KX II-101-V2 will reboot. This
typically takes three minutes.