Select Message Length - Newland NLS-HR200 User Manual

Symbols
Plessey

Select Message Length

It is used to program the valid reading length of Plessey. The engine will not
send barcode message to the Host, if the decoded data length does not match
the valid length.
Plessey Message Length is defined by "Min. Message Length" and "Max.
Message Length ."
Min Message Length (default: 4)
【Pro CMD：0419030】
1D bar code Message Length should not exceed 127 bytes. If Max Message Length is
less than Min Message Length, it means the engine will only support barcodes of the two
lengths. If Max Message Length is equal to Min Message Length, the engine will only sup-
port barcodes of the length.
To set Min Message Length of Plessey to 8 bytes and Max Message Length to 12 bytes,
read these programming codes:
1."Code Programming ON"
2."Select Min Message Length"
3. Digit Code "8", see Digit Code
4."Save Programming", see Digit Code
5."Select Max Message Length"
6. Digit Code "1"
7. Digit Code "2"
8."Save Programming"
9."Code Programming OFF"
nlscan.com
Max Message Length (default:48)
【Pro CMD：0419040】
Tools
Code Programming ON
Code Programming OFF
Page 94