Check Digit - Newland NLS-HR200 User Manual

Symbols
Standard 25

Check Digit

Standard 25 may include Check Digit (not compulsory) following its barcode
message. It verifies the barcode message.
"NO Check, Transmit All" means to read without check and transmit all
»
bytes including barcode message and Check Digit.
"Check, Do Not Transmit Check Digit" means to read and check. If verifica-
»
tion is successful, transmits barcode message; if not, engine will not send barcode
message to the Host.
"Check, Transmit All" means to read and check. If verification is successful,
»
transmits all messages; if not, engine will not send barcode message to the Host.
** NO Check, Transmit All
【Pro CMD：0418050】
Check, Do Not Transmit Check Digit
【Pro CMD：0418060】
When "Check, Do not Transmit Check digit" is enabled and barcode message length
minus one is less than Min Message Length, it will lead to an error.
E.g.：Reading a 4-byte (include check byte) Industrial 25 with the Min Message Length
being 4 bytes and "Check, Do not transmit Check Digit" enabled leads to an error.
nlscan.com
Code Programming ON
Code Programming OFF
Check, Transmit All
【Pro CMD：0418070】
Tools
Page 92