Programming 1D Intercept Option - Newland NLS-HR200 User Manual

Message Interception & Pack Message Interception & Pack
Message Interception

Programming 1D Intercept Option

When programming 1D intercept option, read digit codes as interception
command. The rules is as below：
The interception command format of 1D interception command regards
»
a 3-digit decimal number as a unit.
The interception command has two parts, which are barcode type
»
part(Symbol ID) and data interception part. A command could have several data
interception parts.
A barcode type part(
»
datainterception part uses three units, including intercepting direction
unit:000(Ascending) or 001(Descending), start unit and stop unit.
There is only one type of barcode to be setted to intercept in a time.
»
Intercept EAN-13 from 1st digit to 3rd ascending and from reciprocal 4th to reciprocal 1st:
1、Read "Code Programming ON"
2、Read "Allow Interception"
3、Read "Program Intercept Option"
4、Check Symbols ID Number table for EAN-13
5、Read below digit barcodes
digit 005
Denotes symbol ID
Barcode Type
Note：
1、 Maximum sections of barcode message interception are 5.
2、 Maximum value is 127 for both start digital and end digital
3、 Overlaps of barcode message sections are allowed and work independently.
4、 Start unit and end unit determine its message section. In the above example, descending
"004" and "001" means the section of "last 4th", "last 3rd", "last 2nd", and "last one"
digits.
5、 To intercept only one digit, program start unit and end unit to be the same value.
nlscan.com
Symbol ID) uses a unit, such as "005"; a
000 001
ascending the 1st digit
Data Interception 1
003 001
the 3rd digit descending
Data Interception 2
Tools
Code Programming ON
Code Programming OFF
004 001
the 4th digit the 1st digit
Page 131