Table 1-1. Port Status Leds; Figure 1-3. System Leds; System Status Leds - Enterasys V2H124-24P Hardware Installation Manual

1
Introduction
The port status LEDs have two display modes: Link and PoE. The Link mode
displays the link status and network activity on each port. The PoE mode displays
the PoE power status on each port. Use the Mode Link/PoE button (see "Mode PoE/
Link Button" on page 1-6) on the front panel to toggle between the two display
modes. The current mode is indicated by the Link/Act and PoE system LEDs.
LED
1~24
(Link/Act Mode)
1~24
(PoE Mode)
1-4

Table 1-1. Port Status LEDs

Condition
On/Flashing Green
On/Flashing Amber
Alternate Green/Amber Port has been disabled by the administrator.
Off
On Green
Flashing Green
Flashing Amber
On Amber
Alternate Green/Amber Port has been disabled by the administrator.
Off

Figure 1-3. System LEDs

Status
Port has established a valid 100 Mbps network connection.
Flashing indicates activity.
Port has established a valid 10 Mbps network connection.
Flashing indicates activity.
There is no valid link on the port.
Powered device is connected, but not drawing power.
Powered device is receiving power.
Port has detected a power overload or short circuit and shut
down the port's power.
The power budget for the switch has been exceeded and
the port's power shut down.
No powered device is connected to the port.

System Status LEDs

Link/Act PWR
PoE Diag
25
26 Stacking
Mode
PoE/Link