Refrigeration Data; Defrost Data; Physical Data; Glycol Requirements - Emerson Liebert GXT3 User Manual

Refrigeration Data

note: This data is based on store temperature and humidity
that does not exceed 75F and 55% R.H.
Discharge Air (F) 26
evaporator (F) 18
note: not recommended to control temp by regulating coil
temp allow T-STAT to cycle and control temp.
Btu/hr/ft*
parallel
Conventional
Btu/hr/ft*
parallel
Conventional
*For all refrigeration equipment other than Hussmann use
conventional Btu values.

Defrost Data

Frequency Hrs
OFFTIMe
Temp Term °F
Failsafe Minutes
eLeCTRIC or GAS not Recommended

physical Data

Merchandiser Drip Pipe (in.)
Merchandiser Liquid Line (in.)
Merchandiser Suction Line (in.)
Estimated Charge (lb)***
4ft 1.
5ft 1.5
6ft 1.8
*Dependent on case length and refrigerant type.
*** This is an average for all refrigerants types. Actual
refrigerant charge may vary by approximately half a
pound.

Glycol Requirements

Gravity
GpM pSI
n/A n/A
n/A n/A
n/A n/A
Refrigeration (Cont'd)
Center
1500
1725
Crown
2450
2818
4
54
25
1 ½*
3/8*
5/8*

Units with Slanted Shelves

Refrigeration Data
note: This data is based on store temperature and humidity
that does not exceed 75F and 55% R.H.
Discharge Air (F) 24
evaporator (F)
MUST HAve 25° FAn BLADe
note: not recommended to control temp by regulating coil
temp allow T-STAT to cycle and control temp.
Btu/hr/ft*
parallel
Conventional
Btu/hr/ft*
parallel
Conventional
*For all refrigeration equipment other than Hussmann, use
conventional Btu values.
Defrost Data
Frequency Hrs
OFFTIMe
Temp Term °F
Failsafe Minutes
eLeCTRIC or GAS not Recommended
physical Data
Merchandiser Drip Pipe (in.)
Merchandiser Liquid Line (in.)
Merchandiser Suction Line (in.)
Estimated Charge (lb)***
4ft 1.
5ft 1.5
6ft 1.8
*Dependent on case length and refrigerant type.
*** This is an average for all refrigerants types. Actual
refrigerant charge may vary by approximately half a
pound.
Glycol Requirements
Gravity
GpM pSI
n/A n/A
10
IGIC-CIDM-0909
18
Center
1500
1725
Crown
2450
2818
2
54
15
1 ½*
3/8*
5/8*