Sporland Omnistat Time Clock Program Settings - Emerson Liebert GXT3 User Manual

Rev. 0909
CID Mini With Omnistat
Installer Information Reference Sheet
Installers
The CIDM has a Sporland Omnistat Time Clock that is
factory programmed; therefore, the Setpoint and Defrost
setting does not require setting (Omnistat is locked at
factory and requires unlocking before setting)
Start-up/Checklist
1. Verify power to equipment connection point
(See Figure 1)
. Turn power switch on (located below unit in a 4" x 6"
box). See Figure .
3. The case requires two compressor cycle
temperatures before any setting can be verified.
4. If Setpoint or Defrost setting needs to be verified see
page 7 of Installation & Operation Manual.
Figure 1

Sporland Omnistat Time Clock program Settings

Figure 2
1