Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 185

Appendix C Chassis and Module LEDs
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Table C-4
Table C-4
LED
Status Green
ID
Table C-5
Table C-5
LED
Input 1
Input 2
Output
Fault
ID
OL-18634-01
describes the fabric module LEDs.
Fabric Module LEDs
Status Description
All diagnostics pass. The module is operational (normal initialization sequence).
Red The diagnostic test has failed. The module is not operational because a fault has
occurred during the initialization sequence.
or
he inlet air temperature of the system has exceeded the safe operating
T
temperature limits of the card (a major environmental warning). The card has
been shut down to prevent permanent damage.
Blinking The fabric module has just been inserted and is booting up.
red
or
An overtemperature condition has occurred and the module has powered down.
or
The power was turned off with a CLI command.
or
The module is resetting and both ejector levers are out.
Blinking The operator has activated this LED to identify this module in the chassis.
blue
Off This module is not being identified.
describes the power supply unit LEDs.
Power Supply LEDs
Color Condition
Green The AC input voltage is within the valid range.
Off The AC input voltage is outside the valid range.
Green The AC input voltage is within the valid range.
Off The AC input voltage is outside the valid range.
Green The DC output power is within the valid range.
Off The DC output power is outside the valid range.
Off The DC output voltage and power supply unit tests are okay.
Flashing red Self-diagnostic tests have failed or another power supply failure has
occurred.
Blinking blue The operator has activated this LED to identify this module in the chassis.
Off This module is not being identified.
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
C-5