Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 159

Chapter 8 Removal and Installation Procedures
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Step 2 Align the bottom frame assembly so that its four screw holes align to screw holes in the bottom of the
chassis, and then screw in four screws to attach the bottom frame to the chassis (see
Figure 8-8
Install the side frame pieces by following these steps to attach it to the EMI frame:
Step 3
On the EMI frame, which covers the air intake area on the lower front side of the chassis, loosen and
a.
completely unscrew each of the four captive screws that hold the frame to the chassis.
Pull the EMI frame away from the chassis.
b.
On each side of the EMI frame, align a side frame piece so that its two screw holes align to two screw
c.
holes, each in a corner of the EMI frame. Screw in one screw in each of these holes so that each of
the two side frame pieces is firmly attached to the EMI frame.
d. Re-align the EMI frame to the air intake area on the chassis and screw its four captive screws to the
chassis, and tighten the captive screws to 8 in. lbs.
OL-18634-01
Installing the Bottom Frame
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
Replacing a CompactFlash Card
Figure 8-8).
8-19