Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 67

Chapter 3 Installing a Cisco Nexus 7018 Chassis
Installing the Cable Management Assemblies
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Figure 3-10 Attaching the Upper Cable Management Assemblies to the Rack-Mount Brackets
2 2
1 1
1 Lower cable management assembly 2 Upper cable management assembly
Step 4 Place the top hood (800-31269-01) on top of the two upper cable management assemblies that are
already attached to the rack-mount brackets. Make sure that the side closest to the chassis has two
alignment pins that align with the alignment holes in the chassis as shown in Figure 3-11. Push the top
piece so that its alignment pins enter the alignment holes and the top hood rests against the chassis.
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
3-17
OL-18634-01