Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 175

Appendix A Technical Specifications
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
1 Airflow for cooling the supervisor and I/O
modules
3
Airflow for cooling the power supply units
Figure A-14
1
1
1 Airflow for cooling the supervisor and I/O
modules
3 Airflow for cooling the power supply units
To allow for the Cisco Nexus 7018 switch to take in air from the cold aisle and floor on the right side,
you should route cables on the left front side of the device. If necessary, you can route cables on the
upper right front side of the chassis, which leaves the lower right side open to cooling air from the cold
aisle in front of the chassis. By having the cables on the left side and leaving the left rear side
unobstructed, the exhaust is directed to the hot aisle in back.
OL-18634-01
Airflow for the Cisco Nexus 7018 Chassis
3
2 Airflow for cooling the fabric modules
2 Airflow for cooling the fabric modules
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
Chassis Airflow
2
2
3
A-13