Cisco Nexus 7000 Series Hardware Installation And Reference Manual page 127

Chapter 6 Managing the Device Hardware
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m
Mod Ports Module-Type
--- ----- -------------------------------- ------------------ ------------
1 48
3 32
5 0
6 0
10 48
Mod
---
1
3
5
6
10
Mod
---
1
3
5
6
10
* this terminal session
switch#
Install the EPLDs by entering the install module slot_number epld url command.
Step 2
switch# install module 6 epld bootflash:n7000-s1-epld.4.0.2.img
EPLD image file , built on Fri May 16 20:36:39 2008
EPLD
-------------------------------------------------------
Power Manager
IO
Inband
Local Bus CPLD
CMP CPLD
WARNING: Upgrade process could take upto 30 minutes.
Standby supervisor is being upgraded.
Do you want to continue (y/n) ?
Begin upgrading the EPLD images by entering Y for yes.
Step 3
Do you want to continue (y/n) ? Y
For releases 4.0(2) or earlier, if you updated the power management EPLD image, you must reset the
Step 4
power for the module so that EPLD can take effect (this is not required for release 4.0(3) or later). You
can reset the power in one of the following two ways:
To reset the power for the module, physically remove the module and reinstall it.
•
Note
To reset the entire system, power cycle the system.
•
OL-18634-01
10/100/1000 Mbps Ethernet Module N7K-N148GT-11
10 Gbps Ethernet Module
Supervisor module-1X
Supervisor module-1X
10/100/1000 Mbps Ethernet Module N7K-M148GT-11
Sw Hw
-------------- ------
4.0(2) 0.503
4.0(2) 0.601
4.0(2) 0.900
4.0(2) 0.802
4.0(2) 0.902
MAC-Address(es)
--------------------------------------
00-19-07-6c-c0-6c to 00-19-07-6c-c0-a0
00-1b-54-c1-33-98 to 00-1b-54-c1-33-bc
00-1b-54-c1-16-18 to 00-1b-54-c1-16-20
00-19-07-c1-00-b8 to 00-1b-54-c1-00-c0
00-1b-54-c1-07-88 to 00-1b-54-c1-07-bc
A module reload or just pressing the ejector buttons on the module is not sufficient for this
reset requirement.
Model
N7K-M132XP-12
N7K-SUP1
N7K-SUP1
World-Wide_name(s) (WWN)
-------------------------------------------------
--
--
--
--
--
Serial-Num
----------
JAB11060144
JAB1152010K
JAB114902HF
JAB114402JX
JAB114501RW
Curr Ver New Ver
3.4 3.6
3.23 3.23
1.7 1.7
2.1 2.1
6.0 6.0
Cisco Nexus 7000 Series Hardware Installation and Reference Guide
EPLD Configuration
Status
ok
ok
active
ha-standby
ok
6-33