Init Display First; Onboard Vga; Reset Configuration Data - DFI BL100 Series User Manual

3
BIOS Setup
PnP/PCI Configurations
This section shows how to configure the PCI bus system. It covers
some very technical items and it is strongly recommended that only
experienced users should make any changes to the default settings.
x IRQ Resources
↑↓→←
F5: Previous Values
The settings on the screen are for reference only. Your version may not be
identical to this one.

Init Display First

Onboard When the system boots, it will first initialize the
PCI Slot

Reset Configuration Data

Enabled The BIOS will reset the Extended System Configuration
Disabled The BIOS will not reset the configuration data.
76
Phoenix - AwardBIOS CMOS Setup Utility
Init Display First
Reset Configuration Data
Resources Controlled By
PCI/VGA Palette Snoop
** PCI Express Relative Items **
Maximum Payload Size
: Move Enter: Select

onboard VGA.

When the system boots, it will first initialize PCI.
Data (ESCD) once automatically. It will then recreate a
new set of configuration data.
PnP/PCI Configurations
PCI Slot
Disabled
Auto(ESCD)
Press Enter
Disabled
128
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
Item Help
Menu Level
Warning: If use PCI VGA
"PEG/Onchip VGA Control"
item must be set to PEG
port.
ESC: Exit F1: General Help
F7: Optimized Defaults