Init Display First; Onboard Vga; Reset Configuration Data - DFI LT600-DR/D/L User Manual

PnP/PCI Configurations
This section shows how to configure the PCI bus system. It covers
some very technical items and it is strongly recommended that only
experienced users should make any changes to the default settings.

Init Display First

Reset Configuration Data

Resources Controlled By
x IRQ Resources
PCI/VGA Palette Snoop
INT Pin 1 Assignment
INT Pin 2 Assignment
INT Pin 3 Assignment
INT Pin 4 Assignment
INT Pin 5 Assignment
INT Pin 6 Assignment
INT Pin 7 Assignment
INT Pin 8 Assignment
** PCI Express Relative Items **
Maximum Payload Size
↑↓→←
: Move Enter: Select
F5: Previous Values
The settings on the screen are for reference only. Your version may not be
identical to this one.
Init Display First
Onboard When the system boots, it will first initialize the

onboard VGA.

PCIEx When the system boots, it will first initialize the PCI
Express x16 graphics card.
PCI Slot When the system boots, it will first initialize PCI.
Reset Configuration Data
Enabled
Disabled
Phoenix - AwardBIOS CMOS Setup Utility
PnP/PCI Configurations
PCI Slot
Disabled
Auto(ESCD)
Press Enter
Disabled
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
128
+/-/PU/PD: Value
F6: Fail-Safe Defaults
The BIOS will reset the Extended System Configura-
tion Data (ESCD) once automatically. It will then
recreate a new set of configuration data.
The BIOS will not reset the configuration data.
BIOS Setup
Item Help
Menu Level
F10: Save ESC: Exit F1: General Help
F7: Optimized Defaults
3
8 7