Init Display First; Reset Configuration Data - DFI LanParty LT P35 User Manual

PnP/PCI Configurations
This section describes configuring the PCI bus system. It covers
some very technical items and it is strongly recommended that only
experienced users should make any changes to the default settings.

Init Display First

Reset Configuration Data

Resources Controlled By
x IRQ Resources
PCI/VGA Palette Snoop
PCI Latency Timer (per 8CLK)
INT Pin 1 Assignment
INT Pin 2 Assignment
INT Pin 3 Assignment
INT Pin 4 Assignment
INT Pin 5 Assignment
INT Pin 6 Assignment
INT Pin 7 Assignment
INT Pin 8 Assignment
↑↓→←
: Move
F5: Previous Values
The settings on the screen are for reference only. Your version may not be
identical to this one.
Init Display First
This field is used to select whether to initialize the PCI Express or
PCI first when the system boots.
PCI Express Slot When the system boots, it will first initialize the
PCI Slot
Reset Configuration Data
Enabled
Disabled
Phoenix - AwardBIOS CMOS Setup Utility
PnP/PCI Configurations
PCI Slot
Disabled
Auto(ESCD)
Press Enter
Disabled
8
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Enter: Select +/-/PU/PD: Value
F6: Fail-Safe Defaults
PCI Express x16 graphics card.
When the system boots, it will first initialize PCI.
The BIOS will automatically reset the Extended System
Configuration Data (ESCD) once. It will then recreate
a new set of configuration data.
The BIOS will not reset the configuration data.
BIOS Setup
Item Help
Menu Level
F10: Save ESC: Exit F1: General Help
F7: Optimized Defaults
3
103