Activating Repeater Support; Activating/Deactivating The Dect Interface - Gigaset DX800 A User Manual

Configuring the system settings
Updating firmware automatically
Your base will check daily whether a newer
firmware version is available from the Inter-
net on the configuration server. If firmware
updates are available, the message New
firmware available. Update? is displayed in
the idle display of the base.
§Yes§
Press the display key to confirm
the prompt.
The firmware is loaded onto your base.
If you answer the prompt with
returns to idle status. Your base will no
longer remind you that firmware updates
are available. The message will only be
shown again if a newer version of the
firmware is available to download. You can
also carry out the firmware update manually
¢
( page 137).
Please note
If the base is not connected to the Inter-
net at the time when the check for new
firmware is to be carried out (e.g.,
because the router is deactivated), the
check is carried out as soon as the base is
reconnected to the Internet.
You can deactivate the automatic version
check via the Web configurator.

Activating repeater support

You can increase the range and signal
strength of your base using a repeater. You
will need to activate repeater mode. This will
terminate any calls that are in progress at the
time.
Prerequisite: Eco mode(+) is deactivated.
¢ Ï ¢
v
System
§Change§
Press the display key to activate
or deactivate repeater mode
(³= on).
§Yes§
Press the display key to confirm
the prompt.
138
§No§
, the base
¢
Repeater Mode
Please note
u
Repeater support and Eco Mode /
¢
Eco Mode+ (
each other out, i.e., both functions
cannot be used at the same time.
u
The default encrypted transmission
setting is deactivated when repeater
mode is activated.
Activating/deactivating the
DECT interface
If you deactivate the DECT interface, the
radio connection between the base and the
registered handsets/repeaters is terminated.
Handsets/repeaters are "asynchronous" to
the base. They cannot establish a connec-
tion with the base and no calls are signalled.
Handsets/repeaters do remain registered to
the base and will synchronise with the base
as soon as you reactivate the DECT interface.
¢ Ï Settings ¢
v
¢
DECT Interface
§Change§
Press the display key to activate/
deactivate the DECT interface
(³= activated).
If there are no handsets or repeaters regis-
tered to the base, the base's DECT interface
is automatically deactivated.
If you switch the base to registration mode
¢
( page 112) to reregister handsets/
repeaters, the DECT interface is automati-
cally reactivated.
page 108) cancel
System