Table of Contents
Advertisement
Selecting a connection at each call
Requirement: "Select at each call" has been
assigned to the base instead of a send con-
¢
nection
(
page
136).
~ c
Enter the number and pick up
the receiver. The list of all the
base's connections is displayed.
q
Select a connection.
/ w
§Dial§
Press the display key or the mid-
dle of the control key.
If a dialling plan has been defined for the
dialled phone number (see Web configura-
tor), then the send connection specified in
the dialling plan is used.
Please note
u
You can use the red end key
cancel the dialling operation.
u
You are shown the duration of the call
while the call is in progress.
u
If the call costs are to be transferred,
these are displayed instead of the call
duration for calls made via the ISDN
connection.
u
Dialling with the directory
or call and redial list
you from repeatedly keying in phone
numbers.
u
If you have handsets registered to the
base, you can make internal calls free
of charge
(page
Using an alternative connection/
connection list on the display/function
key
Prerequisite: You have assigned an "alterna-
tive connection" or the list with all config-
ured connections to a display key or func-
¢
tion key
(
page
124).
§Sel. Line§
Press the display or function
key.
q
Select a line.
c /
§Dial§
Pick up the receiver or press the
display key.
T
to
(page 70)
(page 66)
saves
113).
§Dial§
Press
mode on the base (open listen-
¢
ing;
page
~
Enter a number. The number is
dialled approximately
3.5 seconds after the last digit is
entered.
Any dialling plan that has been defined for
the dialled phone number (see Web config-
urator) is ignored. The selected send con-
nection is always used.
Calling an IP address
(provider-dependent)
You can also dial an IP address instead of a
phone number using VoIP.
¤
Press the star key * to separate the sec-
tions of the IP address
(e.g., 149*246*122*28).
¤
If necessary, press the hash # key to
attach the SIP port number of the person
you are calling to the IP address (e.g.,
149*246*122*28#5060).
If your VoIP provider does not support the
choice of IP addresses, each part of the
address will be interpreted as a normal
phone number.
Dialling emergency numbers
Dialling plans for emergency numbers
(e.g., the local police emergency number)
are preset on the base for certain countries.
Emergency calls are then always made via
the fixed line or ISDN.
However, you can change the connection
through which each emergency number
should be called (e.g., if the phone is not
connected to the fixed line/ISDN). You must
make sure, however, that the VoIP provider
for the selected connection supports emer-
gency numbers. If the VoIP connection is
deleted from the configuration, the emer-
gency call can no longer be made.
Making calls
to activate handsfree
57).
51
Advertisement
Table of Contents
