Updating The Phone Firmware - Gigaset DX800 A User Manual

A list of all configured connections and the
Gigaset.net connection is opened. You can
select Yes or No for each connection.
r
Select Yes if you want the rele-
vant connection to be the
receive connection for the inter-
nal party.Select No if it should
not be the receive connection.
s
Change to the next connection.
¤
Repeat these two steps for each connec-
tion.
¤
Press the display key
changes.
Further information on how to assign
receive connections to local answering
machines can be found on
Please note
u
If a new connection is configured, it is
assigned as the receive connection to
all internal parties and answering
machine 1.
u
If a connection is not assigned as the
receive connection to any internal
party, calls on this connection will not
be signalled.
Accepting calls to a Bluetooth GSM
connection
If you wish to accept calls on the base that
are made to the GSM connection of a mobile
connected to that base via Bluetooth, then
you must select the GSM connection as the
receive connection. The name of the mobile
is displayed for the GSM connection in the
list of known devices.
The same applies if you wish to accept calls
via the GSM connection to a handset regis-
tered on the base.
§Save§
to save the
page 97.
Configuring the system settings
Updating the phone
firmware
Prerequisite: The base is connected to the
Internet (i.e., connected to a router,
¢
page 16).
If necessary, you can update your base's
firmware.
The firmware update is downloaded directly
from the Internet by default. The relevant
Web page is preconfigured on your base.
Prerequisite:
The base is in idle status i.e.,
u
No calls are being made.
u
There is no internal connection to/
between the registered handsets.
u
No handset has the base menu open.
Starting the firmware update
manually
¢ ¢
Ï Settings
v
Update Firmware
Select and press
~
Enter the system PIN and
§OK§
press
The base establishes a connection to the
Internet.
§Yes§
Press the display key to start the
firmware update.
Please note
u
The firmware update can take up to
three minutes.
u
When updating from the Internet,
checks are made to ensure that no
newer version of the firmware exists.
If this is not the case, the operation is
terminated and a message is issued to
that effect.
System
§OK§
.
.
137