System; Output Select; Input; Knob Setting - Boss GT-001 Parameter Manual

SYSTEM

Settings that are shared by the entire GT-001 are called "system
settings. "
MEMO
For details on how to make settings, refer to "Editing: Editing the
Effects" (p. 7) in the owner's manual.

OUTPUT SELECT

Specify the device (amp) that's connected to the OUTPUT jacks.
Parameter Value
JC-120
SMALL AMP
COMBO AMP
STACK AMP
SELECT
JC-120 RETURN
COMBO RETURN
STACK RETURN
LINE/PHONES

INPUT

Here you can make settings related to input.
On the GT-001 you can use either the guitar input or the mic input. You can't use both
simultaneously.
Knob Parameter Value
Page 1
Specifies which signal will be received: GUITAR IN or
MIC IN.
SELECT
[1]
GUITAR
(INPUT
SELECT)
MIC
Page 2
GT .LVL
MUTE, -19
[1]
dB–+20
(GUITAR
dB
LEVEL)
MUTE, 0
MIC .LVL
[2] dB–+20
(MIC LEVEL)
dB
PHANTM
[4] OFF, ON
(PHANTOM)
* The sound might be interrupted when you adjust MIC LEVEL or
PHANTOM.
Explanation
Choose this setting if the GT-001 is connected
to the guitar input of a Roland JC-120 guitar
amp.
Choose this setting if the GT-001 is connected
to a small guitar amp.
Choose this setting if the GT-001 is connected
to the guitar input of a combo-type guitar
amp (i.e., a single unit that contains the amp
and speaker) other than the JC-120.
For some types of guitar amps, the "JC-120"
setting might produce better results.
Choose this setting if the GT-001 is connected
to the guitar input of a stack-type guitar amp
(i.e., one in which the amp and speaker are
separate units).
Choose this setting if the GT-001 is connected
to the RETURN jack of the JC-120.
Choose this setting if the GT-001 is connected
to the RETURN jack of a combo-type guitar
amp.
Choose this setting if the GT-001 is connected
to the RETURN jack of a combo-type guitar
amp. You should also choose the "STACK
RETURN" setting if you're using a guitar
power amp together with a speaker cabinet.
Choose this setting if you're using
headphones, or if the GT-001 is connected to
a keyboard amp, mixer, or digital recorder.
Explanation
The input from GUITAR IN is sent through
the effect.
The input from MIC IN is sent through the
effect.
Adjusts the guitar input level. The input is
muted if you select MUTE.
Adjusts the mic input level. The input is
muted if you select MUTE.
While watching the level meter shown in
the same screen, set the level so that it does
not exceed the second line from the top.
Specifies whether phantom power is
supplied. You must turn this OFF if you're
using a mic that does not support phantom
power.

KNOB SETTING

Here you can assign the desired parameters to knobs [1]–[4] in the
Play Screen.
* The settings you make here are only for the knobs in the Play
Screen.
1.
Choose [MENU]""SYSTEM"""KNOB . "
2.
Set the parameter values with knobs [1]–[4] .
Knob Parameter Value
OFF, PATCH, CmpSUS (COMP SUSTAIN), CmpATK (COMP
ATTACK), CmpLEV (COMP LEVEL), OD DRV (OD/DS DRIVE),
OD TNE (OD/DS TONE), OD ELV (OD/DS EFFECT LEVEL),
OD SLV (OD/DS SOLO LEVEL), A: TYPE (PREAMP A TYPE),
[1]
KNOB 1
A: GAIN (PREAMP A GAIN), A: LEV (PREAMP A LEVEL), A:
BASS (PREAMP A BASS), A: MID (PREAMP A MID), A: TRB
(PREAMP A TREBLE), A: PRES (PREAMP A PRESENCE), A: SLV
(PREAMP A SOLO LEVEL), A: MLV (PREAMP A MIC LEVEL),
B: TYPE (PREAMP B TYPE), B: GAIN (PREAMP B GAIN),
B: LEV (PREAMP B LEVEL), B: BASS (PREAMP B BASS), B:
MID (PREAMP B MID), B: TRB (PREAMP B TREBLE), B: PRES
(PREAMP B PRESENCE), B: SLV (PREAMP B SOLO LEVEL),
B: MLV (PREAMP B MIC LEVEL), EQ LC (EQ LOW CUT), EQ
[2] KNOB 2
LOW (EQ LOW GAIN), EQ LMD (EQ LOW-MID GAIN), EQ
HMD (EQ HIGH-MID GAIN), EQ HI (EQ HIGH GAIN), EQ
HC (EQ HIGH CUT), DlyTIM (DELAY TIME), DlyFBK (DELAY
FEEDBACK), DlyHC (DELAY HI CUT), DlyELV (DELAY EFFECT
LEVEL), D1 TIM (D1 TIME), D1 FBK (D1 FEEDBACK), D1 HC
(D1 HIGH CUT), D1 LEV (D1 EFFECT LEVEL), D2 TIM (D2
TIME), D2 FBK (D2 FEEDBACK), D2 HC (D2 HIGH CUT),
D2 LEV (D2 EFFECT LEVEL), ChoRAT (CHORUS RATE),
ChoDPT (CHORUS DEPTH), ChoDLY (CHORUS PRE DELAY),
[3] KNOB 3
ChoLEV (CHORUS EFFECT LEVEL), RevTIM (REVERB TIME),
RevHC (REVERB HIGH CUT), RevELV (REVERB EFFECT
LEVEL), MT LOW (MASTER LOW GAIN), MT MID (MASTER
MID GAIN), MT HI (MASTER HIGH GAIN), PAT LV (PATCH
LEVEL), WahLEV (PEDAL WAH LEVEL), PB LEV (PEDAL
PITCH BEND LEVEL), CH A/B (DIVIDER CH SELECT), NS1THR
(NS1 THRESHOLD), NS1REL (NS1 RELEASE), NS2THR (NS2
THRESHOLD), NS2REL (NS2 RELEASE), GB LOW (GLOBAL
EQ LOW), GB MID (GLOBAL EQ MID), GB HI (GLOBAL EQ
[4] KNOB 4
HIGH), USB LV (USB MIX LEVEL), ACC SW (ACCEL SWITCH),
OD SL (OD/DS SOLO), A/B SL (PREAMP A/B SOLO), A&B SL
(PREAMP A&B SOLO), CmP SW (COMP SWITCH), OD/DS,
PREAMP, EQ, FX1, FX2, REVERB, PEDL FX (PEDAL FX)
MENU
33