Fx1/Fx2 - Boss GT-001 Parameter Manual

EQ
This adjusts the tone. A parametric type is adopted for the high-
middle and low-middle range.
Knob Parameter Value
ON/OFF
OFF, ON
Page 1
LO .GAIN
[1] -20–+20 dB
(LOW GAIN)
HI .GAIN
[2] -20–+20 dB
(HIGH GAIN)
[4] LEVEL -20–+20 dB
Page 2
LM .FREQ
[1] 20 Hz–10.0 kHz
(LOW-MID
FREQUENCY)
LM .Q
[2] 0.5–16
(LOW-MID Q)
LM .GAIN
[3] -20–+20 dB
(LOW-MID GAIN)
Page 3
HM .FREQ
[1] 20 Hz–10.0 kHz
(HIGH-MID
FREQUENCY)
HM .Q
[2] 0.5–16
(HIGH-MID Q)
HM .GAIN
[3]
-20–+20 dB
(HIGH-MID GAIN)
Page 4
LO .CUT
FLAT, 20
[1]
Hz–800 Hz
(LOW CUT)
HI .CUT
630 Hz–
[4]
12.5 kHz, FLAT
(HIGH CUT)
Explanation
Turns this effect on/off.
Adjusts the low frequency range
tone.
Adjusts the high frequency range
tone.
Adjusts the overall volume level
of the equalizer.
Specifies the center of the
frequency range that will be
adjusted by the LOW-MID GAIN.
Adjusts the width of the area
affected by the EQ centered
at the LOW-MID FREQ. Higher
values will narrow the area.
Adjusts the middle frequency
range tone.
Specifies the center of the
frequency range that will be
adjusted by the HIGH-MID GAIN.
Adjusts the width of the area
affected by the EQ centered
at the HIGH-MID FREQ. Higher
values will narrow the area.
Adjusts the low-middle
frequency range tone.
This sets the frequency at which
the low cut filter begins to take
effect. When "Flat" is selected, the
low cut filter will have no effect.
This sets the frequency at which
the high cut filter begins to take
effect. When "FLAT" is selected,
the high cut filter will have no
effect.

FX1/FX2

With FX1 and FX2, you can select the effect to be used from the
following. You can select the same effect for FX1 and FX2.
* Some effects can be selected only for FX2.
Parameter Value
ON/OFF OFF, ON
TYPE Refer to FX1/FX2 TYPE
Selecting the TYPE
1.
Choose [EFFECT]""FX1" or "FX2 . "
2.
Select the type using the knob [4] .
FX1/FX2 TYPE
This is a list of the effects that can be selected for FX1/FX2.
Effect Name TYPE
T . WAH (Touch Wah)
AUTO WAH (Auto Wah)
SUB WAH
—
(Advanced
ADV . COMP
Compressor)
LIMITER —
SUB OD/DS —
(Graphic
GRAPHIC EQ
Equalizer)
(Parametric
PARAMETRIC EQ
Equalizer)
TONE MODIFY
—
(Guitar
GUITAR SIM
Simulator)
AC .GUITAR SIM —
SLOW GEAR —
DEFRETTER
—
WAVE SYNTH —
SITAR SIM (Sitar Simulator) This simulates the sound of the sitar.
OCTAVE —
PITCH SHIFTER —
EFFECT
Explanation
Turns this effect on/off.
Explanation
You can produce a wah effect with the
filter changing in response to the guitar
level.
This changes the filtering over a periodic
cycle, providing an automatic wah effect.
You can use an expression pedal
connected to the CTL/EXP jack to control
the wah effect in real time.
This is an effect that produces a long
sustain by evening out the volume level
of the input signal. You can also use it as a
limiter to suppress only the sound peaks
and prevent distortion.
The limiter attenuates loud input levels to
prevent distortion.
This effect distorts the sound to create
long sustain.
This adjusts the tone. You can adjust the
sound quality in ten bands.
This adjusts the tone. You can adjust the
sound quality in four bands. You can
adjust the sound quality in four bands.
This changes the tone of the connected
guitar.
Simulation of the characteristics of
particular guitar components such as
pickups and different guitar bodies
allows you to switch among a number
of different guitar types all while using a
single guitar.
This transforms the sound of an electric
guitar into the sound of an acoustic guitar.
This produces a volume-swell effect
("violin-like" sound).
This simulates a fretless guitar.
This is a synth sound that processes the
guitar input signal.
This adds a note one octave lower,
creating a richer sound.
This effect changes the pitch of the
original sound (up or down) within a
range of two octaves.
7