Inserting The Batteries; Connections; Dj System Setup - Boss Dr.Sample SP-202 Owner's Manual

Settings may be different depending on the mixer. For
details refer to the owner's manual for your mixer.
Effect: OFF
Effect: ON
Input: line
Input: PHONO
CH 1
CH2
Mixer settings
When sampling from a record, set the mixer fader to the
record player position (maximum).
The volume level during sampling is adjusted by the SP-
202's REC level (page 20, 21) and by the mixer's effect send
level.
DJ system setup
The SP-202 does not contain an amp or mixer. In order to
hear the sound, you will need an amp, audio system, or
headphones etc. Refer to the diagram at right and connect
the SP-202 with your external equipment.
AC adaptor, Audio cables, MIDI cables, stereo head-
phones and microphone are not included. These can be
purchased separately at your dealer.
To prevent malfunction and/or damage to speakers or
other devices, always turn down the volume, and turn
off the power on all devices before making any connec-
tions.
Connections
8
When this occurs, replace the battery immediately.
The contents of the SP-202's internal memory will be pre-
served even if the battery runs down.
When the battery runs down, the BPM display will become
darker than normal.
Detach the lid of the battery case located on the bottom of
the unit, and referring to the diagrams on the bottom, insert
the batteries making sure to observe the correct polarity.
Then close the lid firmly.
Inserting the batteries