Selecting Forward And Reverse Runs (Operation Panel Only - Toshiba TOSVERT VF-S9 Instruction Manual

This function will be displayed as
Ex.
cannot be set during the inverter operating. Always stop the inverter first and then program.
[Setting values]
Default setting
Setting to
When 3 is programmed,
and displayed the original indication (
time. For setting setup parameters, see 4.1.4.
Trip clear
Setting to
(The parameter does not change.)
Cumulative operation time clear
Setting to
Initialize inverter type information
Setting to
us.
5.8 Selecting forward and reverse runs (operation panel
only)
: Forward/reverse run selection
• Function
Program the direction of rotation when the running and stopping are made using the RUN key and STOP
key on the operation panel. Valid when
Parameter setting
Title
Forward/reverse run selection
Check the direction of rotation on the status monitor.
: Forward run
: Reverse run ⇒ For monitoring, see 8.1.
When the F and R terminals are used for switching between forward and reverse rotation from the ter-
minal board, the
Short across the F-CC terminals: forward rotation
during reading on the right. This previous setting is displayed.
will return all parameters to the standard values that were programmed at the factory.
will be displayed for a short time after setting and will then be erased
setup parameter). Trip history data will be cleared at this
initializes the past four sets of recorded error history data.
allows the initial resetting of the cumulative operation time monitor (0 [zero] time).
clears the trips when an
(command mode) is set to 1 (operation panel).
Function
forward/reverse run selection is rendered invalid.
E-11
format error occurs. But if the
Adjustment range
0: Forward run 1: Reverse run
E6580757
5
displayed, call
Default setting
0