Toshiba TOSVERT VF-S9 Instruction Manual page 116

[0: Supply voltage uncorrected,
×
Rated voltage
Input voltage
* The above applies when V/F control mode
selection parameter
Rated voltage
[3: Supply voltage uncorrected,
×
Rated voltage
Input voltage
6
* The above applies when V/F control mode
selection parameter
Rated voltage
The
eration as those to " " and "
age during deceleration, while minimizing decreases in low-speed operating torque due to changes in volt-
age.
output voltage limited]
Input voltage
High
Low
Output frequency
is set to "0" or "1".
the output voltage can be
1 prevented from exceeding the
input voltage.
output voltage unlimited]
Input voltage
High
Low
Output frequency
is set to "0" or "1".
the output voltage can be
1
prevented from exceeding
the input voltage.
settings to " " and "
", respectively, except during deceleration. These settings prevent overvolt-
[1: Supply voltage corrected,
[4: Supply voltage corrected,
* Even if
input voltage, the output voltage will exceed the voltage
adjusted by
than the base frequency 1
" [supply voltage corrected (off during deceleration)] mean the same op-
F-32
E6580757
output voltage limited]
Input voltage
High
Low
Output frequency
output voltage unlimited]
Input voltage
High
Low
Output frequency
is set for an output voltage lower than the
when the output frequency is higher
.