Mba Boot Rom; Enabling Or Disabling The Boot Rom Setting; Booting With The Mba Boot Rom; Bbs Bios-Compatible Pcs - 3Com EtherLink 10 User Manual

E
Enabling or Disabling
the Boot ROM Setting
Booting with the

MBA Boot ROM

BBS BIOS-Compatible PCs

MBA B
OOT
The default boot ROM (factory) setting on the NIC is Disabled. This setting can
be changed through the 3Com NIC diagnostics program.
NOTE: For detailed information on using, configuring, and troubleshooting the
MBA boot ROM, see the documentation for MBA on the EtherCD that shipped
with this product.
To enable or disable the NIC boot ROM setting using the 3Com NIC
diagnostics program:
1 Start the 3Com NIC diagnostics program.
For instructions on how to start the Windows-based NIC diagnostics program
Go to: 3Com NIC Diagnostics
2 Click the Configuration tab.
The Configuration screen appears.
3 Under Network Parameter, select Boot PROM.
4 Open the Set Value list box and select Enabled to enable the boot ROM or
Disabled to disable the boot ROM.
5 Click OK.
The boot process for the MBA boot ROM varies depending on the type of PC
you have (BBS BIOS-compatible or non-BBS BIOS-compatible).
If your PC was purchased recently, it may be BBS (BIOS Boot Specification)
BIOS-compatible. The BBS determines how the system BIOS identifies boot devices
in a PC (such as a CD-ROM drive, a hard drive, or a floppy drive), allows the user
to select the boot order of these devices, and then attempts to boot from each
device sequentially.
Refer to your PC documentation if you do not know which type of PC you have.
To enable a BBS BIOS-compatible PC to boot from the network using the MBA
boot ROM:
1 Make sure that the boot ROM setting for the NIC is Enabled.
For instructions
Go to: Enabling or Disabling the Boot ROM
2 Manually set the MBA as the first boot device in the BIOS for your PC.
Refer to your PC documentation for instructions on accessing and configuring
the BIOS.
ROM
Program.
Setting.