Verifying Successful Installation; Configuring Dynamicaccess Technology - 3Com EtherLink 10 User Manual

Verifying Successful
Installation
Configuring
DynamicAccess
Technology
If the EtherCD Welcome screen is not displayed, follow these steps:
1 Double-click the DA15.EXE file on your hard drive.
The DA15.EXE file is automatically copied to your hard drive during the NIC driver
installation into the following directory:
Windows 95/98 — C:\WINDOWS\SYSTEM
Windows NT 4.0 — C:\WINNT\SYSTEM32
Windows NT 3.51 — C:\WINNT35\SYSTEM32
The file is expanded and the DynamicAccess technology is installed on your PC.
2 Restart the PC.
NOTE: You must restart your PC to complete the installation.
DynamicAccess technology is installed. To verify that the installation
was successful,
Go to: Verifying Successful
After DynamicAccess technology is installed, the following changes are visible in
the Windows Network dialog box:
For each physical NIC installed in the PC, a virtual NIC entry appears in the list
of network adapters.
All protocols are re-bound to the virtual NIC. The bindings to the physical NIC
are still intact.
A 3Com DynamicAccess technology entry appears as a protocol.
A 3Com DynamicAccess technology icon in installed in the Windows
Control Panel.
Contact your system administrator before using DynamicAccess technology
at your site.
NOTE: DynamicAccess technology configuration instructions are intended for
network administrators who have experience installing software and using
management tools for an Ethernet network.
These instructions are for configuring DynamicAccess technology on a local PC.
You can obtain the complete configuration instruction set by expanding the
downloadable file that contains the DynamicAccess technology software.
Go to: http://www.3com.com/dynamicaccess.
NOTE: You need a Web browser to view the complete configuration instruction
set. You do not need to reinstall the software.

Verifying Successful Installation

Installation.
81