Log Settings - LevelOne WAP-6012 User Manual

Log Settings

If you have a Syslog Server on your LAN, this screen allows you to configure the
Access Point to send log data to your Syslog Server.
Data - Syslog Settings Screen
Syslog Server
Server Name/IP Ad-
dress
Minimum Severity
Level
Email Alerts
Email Alerts
Log Queue Length
Log Time Threshold
SMTP Mail Server
Figure 61: Syslog Settings Screen
Select the desired Option:

Disable - Syslog server is not used.

Broadcast - Syslog data is broadcast. Use this
option if different PCs act as the Syslog server at dif-
ferent times.

Unicast - Select this if the same PC is always used
as the Syslog server. If selected, you must enter the
server address in the field provided.
Enter the name or IP address of your Syslog Server.
Select the desired severity level. Events with a severtiy
level equal to or higher (i.e. lower number) than the
selected level will be logged.
If enabled, an e-mail will be sent. If enabled, the e-mail
address information (below) must be provided.
Enter the desired length of the log queue. The default is
20 entries.
Enter the preferred value between 60 and 600, which
determine how often the log will be emailed to you.
Normally, this can be left at the default value. The default
is 600 seconds.
Enter the domain name or IP address of the SMTP
(Simple Mail Transport Protocol) server you use for
sending e-mails.
Access Point Management
73