Setup Using A Web Browser - LevelOne WAP-6012 User Manual

Wireless Access Point User Guide

Setup using a Web Browser

Your Browser must support JavaScript. The configuration program has been tested
on the following browsers:

Internet Explorer V4 or later

Netscape V4.08 or later
Setup Procedure
Before commencing, install the Wireless Access Point in your LAN, as described
previously.
1. Check the Wireless Access Point to determine its Default Name. This is shown on
a label on the base or rear, and is in the following format:
WAP-6012
2. Use a PC which is already connected to your LAN, either by a wired connection or
another Access Point.

Until the Wireless Access Point is configured, establishing a Wireless connec-
tion to it may be not possible.

If your LAN contains a Router or Routers, ensure the PC used for configura-
tion is on the same LAN segment as the Wireless Access Point.
3. Start your Web browser.
4. In the Address box, enter "HTTP://" and the IP Address of the 11N Wireless
Access Point, as in this example, which uses the Wireless Access Point's default
IP Address:
HTTP://192.168.1.1
5. You should then see a login prompt, which will ask for a User Name and Password.
Enter admin for the User Name, and admin for the Password.
These are the default values. The password can and should be changed. Always
enter the current user name and password, as set on the Admin Login screen.
User Name: admin
Password: admin
Figure 6: Password Dialog
10