LevelOne WAP-6012 User Manual page 64

Wireless Access Point User Guide
Data - Status Screen
Access Point
Access Point Name
MAC Address
Country/Domain
Hardware Version
Firmware Version
TCP/IP
IP Address
Subnet Mask
Gateway
DHCP Client
DHCP Server
Ethernet Status
Wireless
Channel/Frequency
Wireless Mode
AP Mode
Buttons
Virtual AP Status
Statistics
Log
Stations
The current name will be displayed.
The MAC (physical) address of the Wireless Access Point.
The region or domain, as selected on the System screen.
The version of the hardware currently used.
The version of the firmware currently installed.
The IP Address of the Wireless Access Point.
The Network Mask (Subnet Mask) for the IP Address
above.
Enter the Gateway for the LAN segment to which the Wire-
less Access Point is attached (the same value as the PCs
on that LAN segment).
This indicates whether the current IP address was obtained
from a DHCP Server on your network.
It will display "Enabled" or "Disabled".
"Enabled" or "Disabled" is displayed for the DHCP server
status.
The current Ethernet status is displayed.
The Channel currently in use is displayed.
The current mode (e.g. 802.11g) is displayed.
The current Access Point mode is displayed.
Click this to open a sub-window displaying Virtual AP Status
about the information of Name, SSID, Broadcast SSID,
Security, Status and Clients.
Click this to open a sub-window where you can view Statis-
tics on data transmitted or received by the Access Point.
Click this to open a sub-window where you can view the
activity log.
Click this to open a sub-window where you can view the list
of all current Wireless Stations using the Access Point.
60