Deleting Frequencies From Channels; Special Features; Using Cycss And Dcs - GRE PSR-295 Owner's Manual

Deleting Frequencies from Channels

1. Press MANUAL.
2. Use the number keys to enter the channel with the
frequency you want to delete.
3. Press MANUAL again.
4. Press PGM to enter the program mode. MAN changes
to PGM.
5. Press FUNC.
6. Press CL. The frequency number changes and 0.0000
appears.

SPECIAL FEATURES

Using CTCSS and DCS
When your scanner stops on a conventional frequency
that is configured for CTCSS or DCS, it checks for a match
between the transmitted CTCSS or DCS code and the
code that is stored with the channel memory. If the trans-
mitted and stored codes match, the scanner stops on
the transmission and allows the audio to pass to the
speaker. If the codes do not match, the scanner resumes
scan operation. If the special "search" code is in use, the
scanner will instantly display any detected CTCSS code
if programmed for CTCSS mode, or DCS code if pro-
grammed for DCS code. You can store the detected code
into the channel memory by pressing ENTER while the
code is displayed.
For more information about your scanner's receive
modes, including CTCSS and DCS, see "Understanding
Your Scanner's Modes" on Page 12. For information on
programming memory channels for CTCSS or DCS op-
eration, see "Programming Channels for CTCSS or
DCS operation" on Page 15.
28
Page 28 2004/07/06, 15:37