Operation; Turning On The Scanner/Setting Volume And Squelch; Storing Known Frequencies Into Channels - GRE PSR-282 Owner's Manual

OPERATION

Turning On the Scanner/Setting Volume
and Squelch
1. Turn SQUELCH until the indicator points to MIN be-
fore you turn on the scanner.
2. To turn on the scanner, turn VOLUME clockwise until
you hear a hissing sound.
3. Turn SQUELCH clockwise, just until the hissing sound
stops.
Notes:
• To listen to a weak or distant station, turn SQUELCH
counterclockwise. If reception is poor, turn SQUELCH
clockwise to cut out weak transmissions.
• If SQUELCH is adjusted so you always hear a hissing
sound, the scanner will not scan or search properly.
4. To turn off the scanner when you finish, turn VOLUME
counterclockwise to OFF.
Storing Known Frequencies Into
Channels
Follow these steps to store frequencies into channels.
1. Press PGM. PGM appears. Then enter the channel
number (1–200) where you want to store a frequency,
then press PGM again.
2. Use the number keys and DELAY/ to enter the fre-
quency (including the decimal point) you want to store.
3. Press ENT to store the frequency into the channel.
Notes:
• If you made a mistake in Step 2, Error appears and
the scanner beeps three times when you press ENT.
Simply start again from Step 2.
• If you entered a frequency that is already stored in
another channel, the scanner beeps three times while
displaying the lowest channel number where the fre-
quency is already stored, the –dUPL– then the fre-
quency you entered flash on the display. To store the
frequency anyway, press ENT again. Press TUNE/CLR
to clear the frequency.
Page 13
13
2003/03/11, 15:46