Storing Known Frequencies Into Channels; Finding And Storing Active Frequencies; Searching The Service Search Band - GRE PSR-200U Owner's Manual

STORING KNOWN FREQUENCIES INTO CHANNELS

Follow these steps to store frequencies into channels.
1. Press SCAN (Orange).
Note: If you want to program FM broadcast into channel, press FM RADIO.
2. Press PGM, then PGM appears. Enter the channel number (1–200; If you
enter FM RADIO mode, 1-20) where you want to store a frequency, then
press PGM again.
3. Use the number keys and • to enter the frequency (including the decimal
point) you want to store.
4. Press ENT to store the frequency into the channel.
Notes:
• If you made a mistake in Step 3, Error appears and the scanner beeps
three times when you press ENT. Simply start again from Step 3.
• Your scanner automatically rounds the entered frequency down to the
closest valid frequency. For example, if you enter a frequency of 151.451,
your scanner accepts it as 151.450.
• If you entered a frequency that is already stored in another channel, the
scanner beeps three times and displays the lowest channel number
where the frequency is already stored, and –dUPL– appears. If you want
to store the frequency anyway, press ENT again. Press CLEAR/PSE to
clear the frequency.
• Press DELAY if you want the scanner to pause 2 seconds on this channel
before it proceeds to the next channel after a transmission ends (see
"Delay" on Page 30). The scanner also stores this setting in the channel.
5. To program the next channel in sequence, press PGM and repeat Steps 3
and 4.

FINDING AND STORING ACTIVE FREQUENCIES

Searching the Service Search Band

You can search for transmissions in the scanner's preprogrammed search
bank. The search bank is divided into four search bands.
20
PSR200U-OM.indd 20 2010/02/22 16:24:43