Manually Tuning A Frequency - GRE PSR-295 Owner's Manual

6. If you want to input text label into limit search bank,
press TEXT. Cursor blinks third line. Enter the text la-
bel using the keypad, then press ENTER. (See Text
Input Chart on Page 18.)
7. Rotate SQUELCH clockwise and leave it set to a point
just after the hissing sound stops.
8. Press SEARCH to start searching. When the scanner
finds an active frequency, it stops searching.
Notes:
• You can copy and save a frequency into a specified
bank, channel, or priority channel when the scanner
finds an active frequency. See "Using Frequency Copy"
on Page 25 to save the frequency. The frequency copy
works only in search banks CB, Air, All Limit, and HAM
band.
• While the scanner is searching, you can use the seek
search by pressing FUNC then 7. Seek Search On. ap-
pears on the bottom line and S appears at second
digit of the second line. The scanner stops at an ac-
tive frequency for five seconds and restarts searching
automatically. The scanner repeats this operation.
You can set Zeromatic on or off by pressing FUNC then
0. Press FUNC then 0 again to reverse the Zeromatic
setting. Whenever this feature is turned on, Zeromatic ON
briefly appears then z appears at the first digit of the sec-
ond line and the scanner stops at the correct frequency.
When you turn this feature off, z disappears and the scan-
ner stops when it detects an active signal. Zeromatic func-
tions only in search banks CB, Air, All, Limit and HAM
band.

Manually Tuning a Frequency

You can manually set the scanner to move through all
receivable frequencies, or select a specific frequency as
a starting point.
1. Press TUNE. Fine Tune and the current frequency ap-
pears. The scanner automatically begins tuning up or
down.
2. If you want to start another frequency, use the number
keys to enter the frequency, then press ENT.
3. Press /\ or \/ to move up or down. When the scanner
finds an active frequency, it stops on the frequency.
24
Page 24 2004/07/06, 15:37