Resetting The Scanner; Initializing The Scanner; General Hints; Birdie Frequencies - GRE PSR-295 Owner's Manual

IMPORTANT: If you have problems with the scanner, first
try to reset it to retain all memory. If that does not work,
you can initialize the scanner; however, initializing clears
all information stored in the scanner's memory.

Resetting the Scanner

1. Turn off the scanner, then turn it on again.
2. Insert a pointed object, such as a straightened paper
clip, into the reset opening on the side of the scanner.
Then gently press and release the reset button inside
the opening.
Pressing the reset button does not clear the scanner's
memory.

Initializing the Scanner

IMPORTANT: This procedure clears all information you
stored in the scanner's memory. Initialize the scanner only
when you are sure the scanner is not working properly.
1. Turn off the scanner, then turn it on again. Welcome To
Scanning Receiver appears.
2. Press 0 then 1 while Welcome To Scanning Receiver ap-
pears. Initializing Please Wait. appears for about 7 sec-
onds.
Do not turn off the scanner until the initialization is com-
plete. When the initialization is complete MAN Ch000 ap-
pears on the top line of the display. 0.00000 MHz appears
on the second line.

GENERAL HINTS

Birdie Frequencies

Every scanner has birdie frequencies. Birdies are signals
created inside the scanner's receiver. These operating
frequencies might interfere with transmissions on the
same frequencies. If you program one of these frequen-
cies, you hear only noise on that frequency. If the interfer-
ence is not severe, you might be able to turn SQUELCH
clockwise to omit the birdie.
The scanner's birdie frequencies (in MHz) are:
Page 35
35
2004/07/06, 15:37