Arpeggiator Setup; Note Menu - Elektron Analog Four Full Reference Manual

THE SEQUENCER
specified by the RNG setting the notes will be reset to their inital values. From there the octave
transpose will be started all over again.
LEG controls the legato of the arpeggiator. This setting will affect the note trigs of the track
even if the MOD setting is set to OFF.
• ON will play overlapping notes legato, releasing the old note after the new one. The
NLEN setting adjusts the length of the notes when the arpeggiator is activated. If not
activated the LEN setting will adjust the length of the notes.
• OFF will send out a MIDI note off message before the start of each arpeggiated note.
LEN controls the length of the arpeggiated notes.
NO2-NO4 selects the offset in semi-tones for three additional arpeggio notes. The offset is
made from the original note trig. The TRK KEY SCALE and TRK KEY NOTE settings found in
the NOTES SETUP menu will affect the note values of the arpeggiated notes.

ARPEGGIATOR SETUP

Pressing [FUNCTION] + [ARP] opens the ARPEGGIATOR SETUP menu. Here the arpeggiator length and note
offsets are set.
Select the length of the arpeggio by turning the E knob. The max length is 16 sequencer steps.
Arpeggio note offsets can be inserted by pressing a [TRIG] key and turning the LEVEL knob. By pressing sev-
eral [TRIG] keys simultaneously it is possible to adjust the note offsets of more than one step.

NOTE MENU

The NOTE menu controls general note settings for the active track. Open by pressing [NOTE]. NOTE menu set-
tings are a part of the pattern, they are not stored together with kits.
The parameter settings seen in the NOTE menu settings are the default settings when placing trigs on the
sequencer. Entering three note trigs, changing for example the note length parameter and then entering three
more note trigs will thus make the last three note trigs share a different note length compared to the first three.
To add individual settings per note, utilize parameter locks. Read more about this feature "PARAMETER
LOCKS" on page 24.
NOT is the default note value.
VEL sets the velocity value. Please note that this value will affect any VELOCITY MOD menu
assignments. This menu is covered on page 16.
LEN sets the note length.
23