Completing The Installation; Installing The Pci Riser-Card Assembly - IBM System x3620 M3 7376 Installation And User Manual

Completing the installation

To complete the installation, complete the following steps:
1. If you removed the PCI riser-card assembly, replace the riser-card assembly
2. If you removed the air baffle, install it (see "Installing the air baffle" on page 79).
3. If you removed the server cover, replace it (see "Installing the server cover" on
4. Install the server in a rack. See the Rack Installation Instructions that come with
5. To attach peripheral devices and connect the power cords, see "Connecting the

Installing the PCI riser-card assembly

To install the PCI riser-card assembly, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Make sure that the server and all peripheral devices are turned off and that the
3. Reinstall any adapters and reconnect any internal cables that you removed in
4. Align the PCI riser-card assembly with the alignment pin and the guide rails on
5. Press down on the blue touch points on the PCI riser-card assembly to install
If you have other devices to install, do so now. Otherwise, go to "Completing the
installation."
78
System x3620 M3 Type 7376: Installation and User's Guide
(see "Installing the PCI riser-card assembly").
page 80).
the server for complete rack installation and removal instructions.
external cables" on page 81.
on page 28.
power cords and all external cables are disconnected.
other procedures.
the chassis.
the assembly in the server. Make sure that the PCI riser-card assembly is fully
seated in the PCI connectors on the system board.
Attention: Make sure that the cables are not pinched.