IBM System x3620 M3 7376 Installation And User Manual page 102

v Date and Time
v Start Options
86
System x3620 M3 Type 7376: Installation and User's Guide
cannot configure Turbo Mode settings in Custom Mode. To have this screen
display configurable fields properly, you may restore the Setup utility to the
factory default settings.
– Integrated Management Module
Select this choice to view or change the settings for the integrated
management module.
- POST Watchdog Timer
Select this choice to view or enable the POST watchdog timer.
- POST Watchdog Timer Value
Select this choice to view or set the POST loader watchdog timer value.
- Reboot System on NMI
Enable or disable restarting the system whenever a nonmaskable interrupt
(NMI) occurs. Disabled is the default.
- Commands on USB Interface Preference
Select this choice to enable or disable the Ethernet over USB interface on
IMM.
- Network Configuration
Select this choice to view the system management network interface port,
the IMM MAC address, the current IMM IP address, and host name; define
the static IMM IP address, subnet mask, and gateway address; specify
whether to use the static IP address or have DHCP assign the IMM IP
address; save the network changes; and reset the IMM.
- Reset IMM to Defaults
Select this choice to view or reset IMM to the default settings.
- Reset IMM
Select this choice to reset IMM.
– Legacy Support
Select this choice to view or set legacy support.
- Force Legacy Video on Boot
Select this choice to force INT video support, if the operating system does
not support UEFI Video Output Standards.
- Rehook INT 19h
Select this choice to enable or disable devices from taking control of the
boot process. The default is Disable.
- Legacy Thunk Support
Select this choice to enable or disable legacy thunk support.
– Adapters and UEFI Drivers
Select this choice to view information about the adapters and UEFI drivers in
the server. You can also select an adapter that you want to configure and start
a configuration program.
– Network
Select this choice to see all of the device options, such as the iSCSI, PXE,
and Ethernet parameters.
Select this choice to set the date and time in the server, in 24-hour format
(hour:minute:second).