IBM System x3620 M3 7376 Installation And User Manual page 92

To install an ac power supply, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Remove the power-supply filler panel from the empty power-supply bay by
3. Slide the ac power supply into the bay until the retention latch clicks into place.
4. Connect the power cord for the new ac power supply to the power-cord
5. Route the power cord through the power-supply handle and through any cable
6. Connect the power cord to a properly grounded electrical outlet.
7. If the server is powered on, make sure that the error LED on the power supply
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 78.
76
System x3620 M3 Type 7376: Installation and User's Guide
on page 28.
pinching the side clip and pulling the power-supply filler panel from the bay.
Save the power-supply filler panel in case you remove the power supply at a
later time.
Important: During normal operation, each power-supply bay must contain either
a power supply or power-supply filler panel for proper cooling.
connector on the power supply.
The following illustration shows the ac power-supply connectors on the rear of
the server.
clamps on the rear of the server, to prevent the power cord from being
accidentally pulled out when you remove the server from the rack.
is not lit, and that the dc power LED and ac power LED on the power supply
are lit, indicating that the power supply is operating correctly.