Rear Logo Cover - HP TouchSmart 9300 Elite Maintenance & Service Manual

Rear logo cover

The rear logo cover is secured with four screws.
To remove the rear logo cover:
1. Prepare the computer for disassembly (see
2. Remove the left and right rear panels (see
3. Remove the 4 screws that secure the cover to the computer.
4. Pry the cover up to disengage it from the computer, and then pull it toward the top and off the
computer. You may experience significant resistance under the HP logo.
Figure 7-45
To replace the rear logo cover, reverse the removal procedures.
Removing the rear logo cover
Preparing to disassemble the computer on page
Rear panels on page 46).
33).
Rear logo cover 71