Optical Drive Connector Board - HP TouchSmart 9300 Elite Maintenance & Service Manual

Optical drive connector board

Description
Optical drive connector board
Optical drive transfer cable, 275 mm
The optical drive connector board is located on the left side of the computer (when viewed from
behind). It is secured by two screws and has two connectors – one to the system board, one to the
optical drive eject board.
Figure 7-30
To remove the optical drive connector board:
1. Prepare the computer for disassembly (see
2. Remove the left rear panel (see
3. Disconnect the two cables (1) from the board.
NOTE:
on the wires.
4. Remove two screws (2) that secure the board to the computer.
58 Chapter 7 Removal and Replacement Procedures
Optical drive connector board location
Be careful not to damage the cable when disconnecting it from the board. Do not pull
Preparing to disassemble the computer on page
Rear panels on page 46).
Spare part number
652311-001
652286-001
33).