3.
Use a Phillips screwdriver to tighten the recessed two brake screws (for the rails) on the
computer. It should take about 5–10 turns of the screwdriver to secure the screws. Take care not
to overtighten the screws.
NOTE:
The tightened brake screws will hold the VESA adapter plate in the locked position, so
that the computer does not slide down once it is mounted on a wall. These screws must be
tighten before placing the VESA adapter plate on the back of the computer.
Figure 7-4
Tightening the brake screws
VESA mount
37