HP TouchSmart 9300 Elite Maintenance & Service Manual page 60

3. To remove a SODIMM, press outward on the two latches on each side of the SODIMM (1) then
pull the SODIMM out of the socket (2).
Figure 7-22
4. To install a SODIMM, slide the new SODIMM into the socket at approximately a 30° angle (1)
then press the SODIMM down (2) so that the latches lock it in place.
Figure 7-23
NOTE:
with the tab on the memory socket.
5. Reconnect and reconfigure the computer. The computer automatically recognizes the additional
memory when you turn on the computer.
52 Chapter 7 Removal and Replacement Procedures
Removing a memory module
Installing a memory module
A memory module can be installed in only one way. Match the notch on the module