Optical Drive Connector Board - HP Compaq 6000 Pro Maintenance & Service Manual

Optical Drive Connector Board

The optical drive connector board is located near the bottom left side of the fan sink. It is secured by
two screws and has one connector.
Figure 7-40
To remove the optical drive connector board:
1.
Prepare the computer for disassembly (see
2.
Remove the small rear cover (see
3. Remove the port cover (see
4.
Remove the stand (see
5. Remove the drive cover (see
6. Remove the memory cover (see
7. Remove the upper rear panel (see
8. Remove the I/O panel (see
9. Remove the outer/left panel (see
10. Remove two screws (1) that secure the board to the computer.
78 Chapter 7 Removal and Replacement Procedures All-in One (AIO) Chassis
Optical drive connector board location
Small Rear Cover on page
Port Cover on page
Stand on page
Optical Drive on page
Memory on page
I/O Panel on page
Outer/Left Rear Panel on page
Preparing to Disassemble the Computer on page
41).
42).
43).
48).
Upper Rear Panel on page
62).
40).
50).
70).
39).