Optical Drive Cables And Connector - HP Pro 3420 Maintenance & Service Manual

Optical Drive Cables and Connector

Description
Optical drive connector cable
The optical drive connector is secured with two screws, and one eyelet screw secures the cable to
the computer. The connector has two cables that connect to the system board.
Figure 7-31
To remove the optical drive connector:
1. Prepare the computer for disassembly (see
on page
2. Remove the rear cover (see
3. Remove the optical drive (see
4. Remove the system board cover (see
5. Remove two screws (1) that secure the optical drive connector to the computer.
6. Remove eyelet screw (2) that secures the optical drive cable to the computer.
7. Remove cable from the metal tabs (3) built into the computer.
62 Chapter 7 Removal and Replacement Procedures All-in One (AIO) Chassis
Optical drive cable location
33).
Rear Cover on page
Optical Drive on page
Preparing to Disassemble the Computer
34).
44).
System Board Cover on page
Spare part number
665726-001
49).