Sony CCD-TRV118 Service Manual page 211

Dubbing a tape easily – Easy Dubbing
(3) Setting your camcorder and the VCR to face each other
(4) Confirming the VCR operation
When the VCR does not operate correctly
• After checking the code in "About the IR SETUP code," set IR SETUP or
PAUSE MODE again.
• Place your camcorder at least 30 cm (12 in.) away from the VCR.
• Refer to the operating instructions of your VCR.
102
Locate the infrared rays emitter of your camcorder and face it towards the remote
sensor of the VCR.
Set the devices about 30 cm (12 in.) apart, and remove any obstacles between the
devices.
VCR
Remote sensor
1 Insert a recordable tape into the VCR, then set the VCR to recording pause.
2 Turn the SEL/PUSH EXEC dial to select IR TEST, then press the dial.
3 Turn the SEL/PUSH EXEC dial to select EXECUTE, then press the dial.
If the VCR starts recording, the setting is correct.
When recording is finished, the indicator changes to COMPLETE.
CCD-TRV418
A/V connecting
cable (supplied)
2
Infrared rays emitter
E A S Y D U B B I N G
S E T U P
I R SETUP
PAUSE MODE
I R TEST
R E T U R N
[ E A S Y D U B ] : E N D
E A S Y D U B B I N G
S E T U P
I R SETUP
PAUSE MODE
I R TEST
R E T U R N
[ E A S Y D U B ] : E N D
CCD-TRV418
0 0 : 0 0 : 0
R E A D Y
NORMAL
0 0 : 0 0 : 0
ENGAGE
REC PAUSE
R E T U R N
EXECUTE
NORMAL