Fisher & Paykel SmartDrive Service Manual page 22

5. (00000101) Phase 1 - Communications Fault
The Display Module has had difficulty communicating with the Motor
Control Module.
Primary Source:
Action:
6. (00000110) Phase 1 - Display Module Fault
The Motor Control Module (Display Module for Phase 1) has received
an incorrect signal from the pressure sensor.
Primary Source:
Action:
7. (00000111) Phase 1 to 6 - Display Module Fault
The Display Module has found a memory fault.
Primary Source:
Action:
Display Module.
Turn off at the wall and on again after 5 seconds
and try again.
1. Check connections of the 12 way harness for
bad contacts, corrosion etc.
2. Check for moisture in the console area. Dry
out if necessary.
3. If still faulty, replace the Display Module.
4. If still faulty, replace the Motor Control
Module. If the new Motor Control Module
corrects the fault, then refit the original Motor
Control Module.
Phase 2 to 4 - Motor Control Module
Fault
Motor Control Module.
Phase 1.)
Replace Motor Control Module.
Module for Phase 1.)
Display Module.
Replace Display Module.
22
(Display Module for
(Display