System Operation; Figure 4-1 Front Panel Vcr Controls; Table 4-1 Front Panel Vcr Controls - Honeywell HTR62 Installation And Operating Manual

System Operation

Sensor
POWER STOP / EJECT
DEW
HI-FI
CST IN
Controls
Sensor
POWER
CST IN
DEW/HI FI (Stereo)
STOP/EJECT
REW
Rev 1.01
This chapter describes how to use the front panel controls to operate the VCR.
shows the location of the controls and
Figure 4-1 Front Panel VCR Controls
REW PLAY FF TRACKING REC VIDEO
A/V SELECT
Table 4-1 Front Panel VCR Controls
Function
Receives infrared signals from the remote control unit.
Turns the VCR on. It automatically turns off after one minute of inactivity.
Use this button for temporary power to program the unit or to change VCR tapes
without turning the vehicle ignition on. The VCR remains powered on for one
minute after the last remote control button has been pressed.
If lit, indicates a video cassette is in the VCR.
If lit, indicates that audio is recording on the tape.
Press this button once to stop the current VCR operation. Press this button a
second time to eject the tape.
Press this button once to rewind the tape or to search through the images from the
most current image backwards.
Press the PLAY button to resume normal playback. The VCR slows down before
reaching the beginning of the tape. When it reaches the beginning, it automatically
starts recording in a loop, if enabled (see
20).
Table 4-1 describes their function.
L AUDIO R
RECM Continuous recording
23
4
Figure 4-1
loop, page
Document 900.0341
12/05